I love gold leaf because it creates a surface that has texture and dimension you just can’t get any other way. When I spotted this vintage chair in the corner of my local thrift store I knew immediately that its crescent-shape back was the perfect spot for a little goal-leaf embellishment! Even though the finish was in pretty bad shape, the chair’s midcentury lines were perfect for keeping the overall look modern and fresh. Keep reading for more details on this golden project. –
Here’s What You’ll Need…
-2 clean, soft-bristle paintbrushes
-An 8-oz. tub of water-based sizing (I used Dux)
-Imitation-gold leaf (I used imitation )
-Black acrylic paint in high gloss
-Clear acrylic polyurethane
-Fabric for to recover the seat (the amount will vary depending on your chair)
Sand and Paint
The first step in bringing new life to this little chair was to lightly sand the body to remove and smooth the worn-out finish. Next, I painted it a glossy black, carefully excluding the little brass caps on the legs and the area I planned to gold-leaf.
Apply the Gold Leaf
Once the black paint was dry, I carefully applied the water-based sizing to the chair back. Keep in mind that the sizing goes on milky white and dries clear and slightly tacky. Once the sizing surface was ready, I applied the gold leaf by gently placing the thin foil sheets onto the chair back until the entire surface was covered. You can use a soft-bristle paintbrush to help maneuver the foil. Don’t worry too much about being perfect; just cover the surface, filling in cracks as you go. You can use a paintbrush or your fingers to smooth the foil and brush away any excess. Once I was satisfied with the gold-leaf coverage I added two coats of clear acrylic polyurethane to protect it.
Tip: To round out the makeover, I did a quick recovering job of the seat cushion using a staple gun and a few yards of black-and-white fabric. If you need a recovering tutorial, here is a simple one!
For more fun gold-leaf projects, check out my !